Member III
Member III
Influencer III
19540
Enthusiast III
23460
Member III
17011
Member III
They will say its knock sensor bank 1 low voltage. If changing dont fix it then look for chafed wiring causing a short.Not today but will be bringing in rig to the shop tomorrow to address a P0327 code that showed up.
Influencer III
19540
Member III
17011
Will do thanks for the tip!They will say its knock sensor bank 1 low voltage. If changing dont fix it then look for chafed wiring causing a short.
Member III
17011
That's gonna be a nice setup.I also finished my fridge platform. Just need a fridge...
Influencer III
19540
The platform is 30” front to back, and 22” wide. I should be able to strap one in lengthwise and be able to get to it from either side.That's gonna be a nice setup.
Member III
17011
I still need my back seats for the kiddos. But having a platform would be good for solo trips.The platform is 30” front to back, and 22” wide. I should be able to strap one in lengthwise and be able to get to it from either side.
the benefits of full size!
Influencer III
19540
I went a long time with the single jump seat in the back. When I acquired the other half of the wonder twins, it had no rear interior at all. Just the excuse I needed to pull the rest out of thecopcar.I still need my back seats for the kiddos. But having a platform would be good for solo trips.
Member III
Off-Road Ranger I
27152
Member III
Man that is brightFigured out mounting for the light the wife gave me for Christmas.
Should do the trick when a little extra light is needed.
Steward I
25230
Member III
20468
Member III
17011
Just got back from the shop (crying $$) and they did not provide details on the physical parts, other than they confirmed the P0327 code, recommended to replace both sensors and harness, then did the corresponding repairs of adding sealant around sensors, added knock sensor boot, added gasket kit, etc. On my paperwork I see something that says 131k OHMS. If that is supposed to do something with voltage, then maybe that was the root cause of problem?They will say its knock sensor bank 1 low voltage. If changing dont fix it then look for chafed wiring causing a short.