diy

  • HTML tutorial
  1. CapeXterra

    CapeXterra's Build

    Username: CapeXterra Intro: I've only had this rig since Nov. of 2015. Purchased it to replace my previous rig that had seen much better days. My thoughts were this is a much more capable rig than its predecessor an 03 Trailblazer with a 3" lift. I needed something for hauling my 3 kids and...
  2. SCrunner

    DIY kitchen & drawer system in 2016 runner? For NOOBS!?

    Lately I have really wanted to install a kitchen setup in the back of my 4runner but I refuse to pay those prices. I do not have any building skills or power tools, I am curious of any ways to make this possible? I don't need anything crazy. (no spare tire rack to hold items) I want a fridge on...
  3. Ryan Welch

    Wrangler Rear Cargo Storage Drawers & Pull out table

    I wanted to build a rear cargo drawer system for my 2016 Jeep Wrangler 4door. I did quite a bit of research and found some really good info out there but not a ton out there specific to the Wrangler. I’m not an expert builder by any means. I enjoy it and can get by, but I’m no master...
  4. Captain Josh

    DIY Awnings

    I've seen some posts on here from folks who have built their own awnings. What sorts of fabrics did you use? Are they able to be folded/rolled up like the production ones? Any build threads? I'm thinking of going the DIY route and am looking for inspiration and ideas. Looking forward to see...
  5. Tom K

    3D Printed FJ Grille Overland Bound Badge Mount

    I have one Overland Bound member badge on the back of my FJ, and I've been planning to mount the other one somewhere up front for a while. I hadn't found an easy way to get a clean mount - you need something with a nice flat surface for the badge to stick to, and then you need a way to securely...
  6. Trotto17

    DIY Roof rack

    Working on plans for a roof rack for my 5th Gen 4Runner. This is the specs have come up with so far, what are your thoughts? [/IMG]
  7. SLO Rob

    DIY Hi Lift Mounts-advice please?

    So I had some mounts fabricated by a guy on a 3rd Gen 4Runner board for my new hi lift that I like to refer to as a Spanish Inquisition Device. You remove two tie downs just inside the lift gate and put in the mounts et Viola. BUT, I have caveman-like mechanical skills, I broke off the screw...