Search results

Finished the propane connections and fired up the Blackstone!! How glorious it is to smash a Venison/bacon, onion, poblano and mushroom provolone goodness!! Remember, fast food is just a running herbivore!

Almost complete

Well I can finally say that I am 99% complete with all the big items on my drawer system. There are and always will be little things that need to be done or revamped. One more hinge system for a storage drawer lid, finding a cutting board that fits and then finalizing the propane and water...

Curious how you ended up mounting your radio?

Final disassembly and glueing of the center cabinet!

Final disassembly and glueing of the center cabinet!

Which one??

My truck has a removable panel under the steering wheel so I was able to use a nut & bolt. If there is a brace behind the plastic, I would drill a hole and use a nut & bolt but self tappers are ok too. Obvious disclaimer is to make sure you don’t drill thru a wire or anything of use…

Fridge tie downs complete! Plus a mount for the iPad for movie night!

Getting the final "nickel & dime" items knocked out. So I had to think about an easy way to use my water without disconnecting a hose. Requirement is for cold water for cooking, drinking and washing. Hot water for washing dishes, general clean up and showers (not daily). So I made a bracket that...

I've been busy today. I am making changes to the El' Cheapo Air Compressor. I tapped out the 1/8" factory thread to a normal 1/4" air chuck fitting. I need to get a 1-2" nipple to extend the quick release fitting past the housing. Keep in mind, I only used this 2 times, 1 for 20 minutes and 1...

ALMOST there!!! Fridge side slide is 95% complete. Hinges for the rear storage lid, fridge tie downs straps, a cutting board and the final facia cover is all that is left. I pulled it apart and did the final glue and square and edge banding.

Lookie what came in the mail!! What sucks is that the "new" Dorman cab mounts I bought JAN 2024, 3 of 8 already went bad. I wrote them and they refunded all 8 (<$500 refund check)....Pleasantly surprised I didn't have to fight it...So I bought S&B Filters brand. Fun times!

I have a 2014 F350 but when I took my dash apart, that front bezel around the stereo hid all my screws to the other panels. It sucks but you might have to take off 3-4 pieces just to get to that bottom kick tray. I googled it but everything I saw had the center console and yours doesn't. Best...

I am going to be there and am looking forward to meeting other OB members. I have a friend who I have not seen in 13 years is coming out of Michigan to spend the weekend!! Cant wait! I haven't decided if I am doing the Discovery tour yet because of the 20 hour drive from SWFL. But that can...

Yeah they are a little wonky. My friend who is a carpenter said to use magnets to hold down so I will try these. If it doesn’t work I will rethink it. I really like the shelf aspect!! Final punch out in the works. April can’t come fast enough (Moores Expo trip)

Does anyone have these type of hinges installed and are actually using them? The ones I bought wiggle so much, do not sit flat when collapsed. Looking for specifics and where you bought them. Amazon only has variations to these cheapos! Maybe it’s my install, maybe just my understanding but...

Tested my fridge overnight to see how much energy it draws from the batteries and to see if it cools properly. The only other power draw is the CO2 sensor. The variances between the 2-ThermoPro sensors and internal fridge sensors are definitely different. Test ran from 9pm to 7am. Initial temp...

Made from scratch a box corner cushion with 2” memory foam to use as a sleeping pad! www.sailrite.com made it look easy! Recommended web site!