Where did you install your OB emblem?

[Rokketz]

REDARC folks are absolutely fantastic, i had the tech support call me from Australia to help me troubleshoot some wiring issues i had. I have a BCDC2410 and absolutely love it, its tucked away inside my rear bottle jack compartment and i have my solar feed going into it as well as the alternator feed with a little external led light to tell me when its on.

i have a 24v setup with two badass northstars ....i can run my fridge for about 6 days with no prob (and thats with ZERO charging back up from solar or alternator...

 

[Shipwreckedxj]

Just like on a wrangler, driver front fender

 

[grubworm]

Just like on a wrangler, driver front fender

nice! on a jeep, it helps hold the fender on

 

[WoodcockFamilyOverland]

Just installed mine, pin stripes were earned of course ;)

 

[Shipwreckedxj]

Just like on a wrangler, driver front fender

thought i would post a picture since i finally got around to taking one

 

[DinDinh04]

Driver side rear, gave it an angle for climbing lol

 

[Wicked.Yoda]

We stuck a magnetic backing to ours. It’s currently attached to the dashboard in the FJ60. But we can throw it on the outside of the rig as well!!

 

[Rich_the4x4podcast]

It's still sitting on my workbench.

 

[WoodcockFamilyOverland]

We stuck a magnetic backing to ours. It’s currently attached to the dashboard in the FJ60. But we can throw it on the outside of the rig as well!!View attachment 153889View attachment 153890

That’s a brilliant idea!

 

[Brett L.]

So, after thinking about where to place these things for what felt like forever, I finally decided on placing them right above the TRD Pro emblems on the rear pillars. I stared at it for a bit and thought "I'll use the bottom of the letters T, D, and Pro" as a way to create a straight tape line since I couldn't find a body line to use as a reference. Measured it out to make it as centered as possible between both windows, removed the tape, and lined it up with the straight line on the emblem. "That looks great!" I thought. That was until I got to the other side and realized that because the TRD Pro emblem faces a different direction, the gap between the TRD Pro and OB emblems is off on both sides despite using the same method for placement. Damn it Toyota! (Yeah, it's their fault.)

Anyway. The emblems added +5 horsepower and gave me an additional 1" of articulation so whatever.


Edit: I remedied the situation.

 

[DizzyDoyle]

I put mine on the front grill of my 4r. Will place the 2nd one on my camper once it is finished being built!

 

[Kilo_17]

Driver side C pillar on our 4runner

Left rear on the X

 

[AllenK]

frames up nicely on the ole G

 

[WilhelmB]

i

 

[Trailman8812]

On the fender,

 

[MoreGone]

Just got my replacement badge for my new rig! What do you guys think?

 

[JustinH]

Just got my replacement badge for my new rig! What do you guys think?

View attachment 155109

Windows that roll down.. Who needs those. Looks great!

 

[Roverbob]

Under the left tail light of my discovery 2

 

[kooner2k]

Drivers side door ,just below the mirror. Thanks again for accepting me into this group......

 

[MoreGone]

Windows that roll down.. Who needs those. Looks great!

I decided I want to put it where the Trail Rated Badge is. Decided to have a little troll until I take the time to remove the badge so currently don't have my member badge on the Jeep yet