What is the last thing you bought and plan to buy?

[Cypress]

Looking into the rear bumper spare swing arm set up. Not sure which is more important, rear, or front bumper with winch set up? Not a fan of my front bumper guard now, but it came with it and free is hard to beat.

If you travel primarily by yourself, I'd go for the winch and front bumper. If you always run with groups, that's less important.

 

[OCToyCruiser]

Looking into the rear bumper spare swing arm set up. Not sure which is more important, rear, or front bumper with winch set up? Not a fan of my front bumper guard now, but it came with it and free is hard to beat.

If you travel primarily by yourself, I'd go for the winch and front bumper. If you always run with groups, that's less important.

That’s a good call, thanks for the advice. Im looking forward to going out with others eventually. In the meantime, exploring alone.

 

[roots66]

Picked up this deal. Free on CL and just 20 minutes away.

 

[xc70az]

Last thing we bought was a Canyon Outfitter 55 Cooler. Plan to (eventually) buy some type of collapsing table for the camp stove. I'm all about keeping the weight down for vehicle handling and MPG, so still deciding which one.

 

[MegaBug]

Just ordered some RCI sliders and skid plates for our new 4Runner build. Now the wait begins :-)

 

[Tom Cole]

I just had a Long Range Aux (LRA) tank installed on my 4Runner. I went to BBRSP and off-roaded for 5 days and still had 17 gallons left over when I pulled into Marfa. Years past, I always had to take 3 rota-pax to do the same trip.

 

[velo47]

Ordered a Relentless Fab rear bumper and swingarm for the truck. And some Luci lights at 50% off (the lights, not the bumper)!

 

[Atypical]

A front bed mount setup for my Maxtrax boards on a 2020 Raptor. Not many options out there but I found a couple of seperate pieces to make it happen I think. I was looking for a no drilling into the bed solution along the lines of the Builtright bed racks. I even contacted Builtright if they had anything in the works but unfortunately they haven't fully figured out an option quite yet. Fingers crossed it works.

 

[surfnturf]

I just bought a clean CJ7!

I was starting to feel guilty driving my classic Bronco to all these far away places and figured that a less expensive to replace rig was in order. I'm keeping the Bronco but will retire it to local trips to the beach on weekends. This is my "new" daily driver and overland rig! It's already set up nice with Dana 44s front and rear, Lockers (ARB) , 4:1 transfer case. Cruises 65 on the freeway comfortable and crawls with 115:1 ratio. Setting it up to tow my overland trailer and few other goodies. Stay tuned....

 

[RoarinRow]

I just bought a clean CJ7!

I was starting to feel guilty driving my classic Bronco to all these far away places and figured that a less expensive to replace rig was in order. I'm keeping the Bronco but will retire it to local trips to the beach on weekends. This is my "new" daily driver and overland rig! It's already set up nice with Dana 44s front and rear, Lockers (ARB) , 4:1 transfer case. Cruises 65 on the freeway comfortable and crawls with 115:1 ratio. Setting it up to tow my overland trailer and few other goodies. Stay tuned....View attachment 178639View attachment 178640

Looks like a fun rig!

 

[BlueLineOverland]

ARB bumper!!!

 

[4Ruffner]

CBi Full Skid Plates w/ Tank plate should ship ... soon?
Ordered ARB OME BP-51 Lift Kit & Full Suspension with OME upper control arms yesterday.
Hopefully they will both arrive in a week or two at Parry Motors to be installed at the same time as the LRA tank.
Now, just need to get some BFG KO2s by that time ...

 

[Johnnyblender]

Partner Steel 22 inch stove

 

[ThundahBeagle]

I just bought a set of 17 inch, 7 spoke steel rims with studded snow tires for my 2014 GMC Sierra.

My next purchases will be in line with getting my 100,000 miles service needs completed

Then I plan to replace those snow tires with 33 inch A/T tires.

Ultimately I would like to turn this

 

[ThundahBeagle]

Into something like THIS

 

[ThundahBeagle]

With a stance like this

 

[ThundahBeagle]

With the help of THESE rims

 

[LostWoods]

A whole lot of crap to build a full platform in the back seat. Going to pull the 60% Goose Gear platform I have and use it as a base before going ham to correct the issues I have with it.

Next will be the fridge I'm updating the aforementioned platform for... likely a CFX3 55IM or something similar.

 

[vinayyelluri]

Recently upgraded to Icons 3.5inch lift on my 4runner, now looking to get a winch and snorkel

 

[RoarinRow]

Into something like THIS
View attachment 179377

I seen this version in person, I like it!