What Did You Do With Your Rig Today?
- Thread starter iamout
- Start date
What material are you using for these screens? Where did you get it? I need to make some for my camper for my dogs.
Influencer II
Just picked up my new skidplate, will get it on my car tomorrow, will upload a pic when that is done
It’s a 18ga mesh from OSH 24x30 this one is coated in a light black coating & doesn’t have sharp edges on the either face much safer for the my pups noses, I used a cutting wheel, instead of sheers that had caused the coating to come off so I just touched it up with rattle can black lol may send it out and get it re coated ( note you could probably get a larger sheet in a heavier gauge if needed at a metal supply ) OSH is closing so it was 30% off [emoji51]
Member II
Member III
That’s the million dollar question lol, they were press fitted and staying in but need to secure them in place, at this moment I’m going to use some washers to over lap and screw to the door frame, I’d really like to make a trim panel may weld up something at work once I see how this functions
Influencer II
Changed my mind and bolted up the skidplate, all I need to do now is torque it to spec
Educator I
- 10,890
- First Name
- Jim
- Last Name
- Bro
- Member #
-
12989
- Service Branch
- USAF DAV
Waldo can I ask, what Jerry can mount is that and what can, any leak issues? Also curious about the RTT, about what size is that?
Jim
Educator I
- 10,890
- First Name
- Jim
- Last Name
- Bro
- Member #
-
12989
- Service Branch
- USAF DAV
Just completed a 4 day camping trip in the Kaibab NF south of Williams Arizona, wow what a beautiful place and I sure needed it........Couple picks:
Member III
Nice job. I just got a torque wrench...ya wanna borrow mine....oh! Never mind...shipping would be a killer. [emoji12] [emoji41]
Traveler III
Just use the universal german torque spec: make it gudentight.
Member III
Member III
I found out what I thought was a scraping noise when I went through ditches was actually my bumper bending oops
Influencer I
Finished loading up and arranging my custom fabbed FZJ80 over-dash bar for mounting various RAM fittings for NAV, Lighting Mgmt, iPhone, iPad, GoPro, and 2 swivel cup holders. It’’s ridiculously functional and cool. I don’t think anything else will fit!!
I wish I had taken a closer look at your setup that day as for the mounting of the main bar [emoji1303]
I would love to see a follow up or new thread on how to do this. I would like something like this. Good job!
Influencer I
I replied from my phone yesterday and it placed the comment in a separate thread. Hope this one lands in the correct spot! I went with the K470 series.
Ya my reply ended up in my post LOL it’s all good thanks for getting back to me [emoji1303] gonna check those out
Built v2.0 of my drawer/storage solution.
Then went out and field tested it for the weekend.
Then went out and field tested it for the weekend.
