Enthusiast II
Rear bumper + tire/gas carrier.
- Thread starter XPdriven
- Start date
Influencer II
I'll let you come build me one, if you want ;) I'll supply beer....
Enthusiast II
Yes sir. Took longer than I thought because I kept adding onto it but it was a lot of fun.
Sent from my HTC One M9 using Tapatalk
Pathfinder III
Enthusiast II
Pathfinder III
Enthusiast II
It's a spindle. Got it from A to Z fabrication.
Sent from my HTC One M9 using Tapatalk
Pathfinder III
@Robert OB 33/48 I used the same part for my swing gate, essentially it's an axle from a small trailer. It has a 1.5" solid steel pin, two cartridge bearings and an outer race with a 2.25" outer diameter. I think it's rated for 2000lbs. If you visit atozfabrication.com they have it listed under builder parts. I would think something similar would be available over there, maybe from some place that sells small utility trailers?
Influencer I
That looks damn nice......
Now, rotate that Jerry Can holder 90 degrees and make room for another Jerry Can, or Water, or C02 Tank. You've done all the hard work now mount some Stuff.......
Now, rotate that Jerry Can holder 90 degrees and make room for another Jerry Can, or Water, or C02 Tank. You've done all the hard work now mount some Stuff.......
