question about backspacing on wheels

[Jeepmedic46]

I don't understand back spacing on wheels. Apparently on my 2000 Jeep Cherokee with 255/75/17 inch tires and wheels. My wheels are rubbing and i was told I had to much back spacing on my wheels. The Jeep has a 4.5" lift on it and came with the wheels and tires.

 

[Grendel]

Offset is the measured distance between the hub mounting surface and the wheels center line.

With X being the determined offset, the hub mounting surface on positive offset wheels is X amount forward from the wheel center line. The hub mounting surface on negative offset wheels is X amount backwards from the wheel center line. The hub mounting surface on 0 offset wheels is the wheel center line.

Backspacing is the measurement from the hub mounting surface to the back edge of the wheel.

***Typically speaking, the higher the offset/backspace, the more the wheel will tuck inwards towards the suspension or away from the fender. The lower the offset/backspace, the more the wheel will push out away from the suspension or towards the fender.

For Example:

*If the offset on a 9" wide wheel is +12mm, the hub mounting surface will be 12mm forward from the wheels center line. Measuring from the hub mounting surface to the back edge of the wheel, the backspacing is 5.5"

*If the offset on a 9" wide wheel is -12mm, the hub mounting surface would be 12mm towards the back of the wheel from the wheels center line. Measuring from the hub mounting surface to the back edge of the wheel, the backspacing is 4.5"


Here's how to calculate the backspacing using the rim width and offset:

First - add 1" to the rim width and then divide by 2 to find the wheels center line (you have to account for the wheel flange which is why you add 1" to the rim width) . Second - convert the offset which is in millimeters into inches. There is 25.4mm in 1 inch so divide the offset by 25.4. Lastly - add the converted offset to the wheels center line if the offset is positive for the correct backspacing. Subtract the converted offset to the wheels center line if the offset is negative for the correct backspacing.

For Example:

17x9 +12mm offset

*9" rim width + 1" = 10"
*10"/2 = 5" (wheels center line)
*+12mm offset/25.4 = 0.47" (0.50" rounded up)
*0.50" + 5" = 5.50" Backspace


17x9 -12mm offset

*9" rim width + 1" = 10"
*10"/2 = 5" (wheels center line)
*-12mm offset/25.4 = 0.47" (0.50" rounded up)
*0.50" - 5" = 4.50" Backspace

 

[Prerunner1982]

Looks like you may be running JK wheels which means you should have adapters too but it's likely the adapters aren't thick enough to overcome all of the back spacing.

 

[Jeepmedic46]

This is what my wheels look like. I have very big spacers.