1986 FJ60, owned since 1989.
IF I can recall the mods/upgrades, here you go;
rebuilt engine with milled head, stainless headers, 2 inch stainless exhaust with Borla muffler, camshaft suited for fuel injection
GM TBI fuel injection (see update @ bottom)
Toyota H55f 5 speed
4.56 gears
33 by 10 inch BFGs
Thomas oil free air compressor for Goodyear rear air bags, with in-cab controller, also for air horns, auxiliary air tank and ARB rear locker
dual batteries with dual battery bracket and heavy duty battery cables (Urban Land Cruisers) for the starter battery, (Group 31 + 34) with controller; had to modify/ the inner driver's fender to fit in that big Group 31 battery!
new Alcan springs, lifted about 3 inches
Bilstein shocks all around
ARB locker in rear
Power Brute limited slip in front
hitch receiver
8K Ramsey winch
rocker rock sliders with double wall tubing
12 volt National Luna fridge
heavy duty drawers in rear from Australia
rear seat removed, now has platform for our dogs with storage underneath
Front Runner upright and footwell water tanks, 10 gallons each, in rear seat area, plumbed together
no rust
aluminum roof rack by East Coast Bullbars (ECB) of Australia (not installed)
Canadian M101 trailer with custom locking aluminum lid with spring & air supports (rarely used)
Wagon Gear tail gate storage,
CB
H4 headlight conversion with ARB headlight relay kit
PIAA 90 Pro lights, fog & driving lights; driving lights come on/off with high beam switch and both fog & driving lights have their own on/off switch
color matched passenger hand grab handle
GM (higher output) alternator with smaller pulley for greater, lower RPM output
new: seals and bearings everywhere, u joints, clutch, speedometer, windshield and seal, etc.
lengthened brake lines
lengthened and balanced front driveshaft
motor and trans mounts replaced
transfer case rebuilt
new front carpet
new radio (now working so/so)
under hood shower
Held Racing billet aluminum rims, powder coated clear
rear anti sway bar
front & rear tow hooks
differentials & transfer case/transmission high location vent tubes
engine block heater (by Toyota)
large Toyota left & right side view mirrors
rubber floor mats
rear and back windows tinted
MANY spares
And undoubtedly more I can't recall since this work was completed over the years to keep the vehicle "overlanding ready"!
Soon to be installed (next week!): Holley 2 barrel Sniper fuel injection, it JUST came to market, should be great!