Jeep JK limb risers

[TangoHotel]

Hello all. I've been wanting to make limb risers for my 2 door Rubicon and just don't know what gauge steel to use for the brackets. Obviously something strong enough but thin enough to to fit on the interior of the a pillar of the windshield.

Sent from my Moto E (4) Plus using OB Talk mobile app

 

[Phildirt]

Hello all. I've been wanting to make limb risers for my 2 door Rubicon and just don't know what gauge steel to use for the brackets. Obviously something strong enough but thin enough to to fit on the interior of the a pillar of the windshield.

Sent from my Moto E (4) Plus using OB Talk mobile app

I tried the A-pillar thing and took them off after 2 days because of wind noise through the seal. May want to hook them to your roof rack if you have one.

 

[SubeeBen]

I made a pretty nice set of limb risers IMO for about $ 60 View attachment 58532 View attachment 58534 but mine are connected to my rack. O wind noise. Can give you material list if needed.

 

[mjbateman01]

I have a Jeep cherokee, but would love a parts list. I know i will probably have to make the wire part a little longer to go to my roof rack

 

[TangoHotel]

I don't have roof rack though. Any suggestions?

 

[TheRubiconLife]

Loos great, good job.

 

[Stepsride]

I don't have roof rack though. Any suggestions?

There are many DIY solutions with and without a roof rack. If you have a light bar you can use those provisions to run a cable from there to the hood releases. Or you can use the below link which is one of many. I was looking at these since the price is not all that bad. However I have no experience with this product.

http://haukoffroad.com/by-vehicle/jk-products/accessories/jk-limb-riser/