We recently bought the diamondback tonneau cover with the Front Rummer Slimline rack system from Diamondback. The cover is very nice and pretty straight forward to install. Getting the rack install onto the cover was a nightmare. Having to drill holes into a $2100 cover was nerve racking, and yes I did miss it up pretty badly. There are a lot of hardware and supports that you have to navigate your drilling around, not easy to do. The frontrunner rack from diamond also came with a pretty should cross bar. It came with 58in cross bars, this for a full size F150 the rack should have come with the maximum 62 inch bar. The bars look a little short on my truck. Anyway the rack is finally installed, I will never do this again. Now I just have to figure out how to close and seal over a dozen holes I drilled into this beautiful cover.
The frintrunner rack and diamond back did not come with any templates or usable install directions, a link to a video would have been extremely helpful.
The frintrunner rack and diamond back did not come with any templates or usable install directions, a link to a video would have been extremely helpful.
