Can anyone identify this suspension setup on (not my) DIY trailer?

[gr33nmachin3]

Hello!

I purchased a diy overlanding trailer with roof tent last year and have traveled around with it a bit.

Anyone recognize the suspension on my trailer?

I did not build the trailer (an unknown previous owner did) but was told it is a Ford auto suspension (Escort perhaps?)

I'm researching so I can refresh bushings, shocks, springs, hubs etc. as necessary when the time comes.

Thank you!

 

[smritte]

It does look like someone pulled a rear suspension out of a front wheel drive car. The trailing arm design looks very old. Easy pre 90's and possibly pre 80's. I say that because of the stamped arms and the way the lower spring buckets sit. I would be very surprised if it was newer.

Bushing wise, its going to take a bit of searching. You need all the dimensions first, which means disassembly. Once there I would start with ford and cross reference the dimensions. I've found odd bushings and bearings that way. You may want to start with the bearing dimensions and see what car you end up with. I've had better luck with those. Be aware, quite a few of those suspensions didn't have replaceable bushings.

Shock's are easier. Extended length, collapsed and mount design. You find shocks with the length numbers then look up mount type. Its possible your shocks are not from the same car. Most of my shock lengths (for trailers) end up being old lowered bug front.

Springs, if they hold up the weight and you don't see damage, just repaint them.

 

[eriefisher]

Hard to say for sure. What is the wheel bolt pattern? May help to narrow it down.