5th Gen 4 Runner CB Antenna

  • HTML tutorial

LNR4FUN

Rank II
Member

Contributor III

327
Davis, California, United States
First Name
Matthew
Last Name
Montgomery
Member #

24408

Hello all!

I’m trying to run a CB cable to an antenna that I will be mounting on my rear TJM bumper. Essentially, I will need to come out somewhere by the rear tailpipe to run up the swing out to the CB antenna mounting location. I’m trying to figure out the best place to exit the cable from inside the truck. Is going through the plug in the floor (center) of the cargo area my best bet?

Thanks!
 

M Rose

Local Expert
Mod Team
Member

Advocate III

5,584
Northeast Oregon, United States
First Name
Michael
Last Name
Rose
Member #

20990

Ham/GMRS Callsign
W7FSB
Service Branch
US ARMY Retired
Hello all!

I’m trying to run a CB cable to an antenna that I will be mounting on my rear TJM bumper. Essentially, I will need to come out somewhere by the rear tailpipe to run up the swing out to the CB antenna mounting location. I’m trying to figure out the best place to exit the cable from inside the truck. Is going through the plug in the floor (center) of the cargo area my best bet?

Thanks!
I would exit out the tail light housing hole...
 

tw1st3d5

Rank IV
Launch Member

Enthusiast III

1,246
Florissant, CO, USA
First Name
Jason
Last Name
Kee
Member #

13455

There are rubber grommets on either side of my 5th gen (had third row seats) right behind the wheel wells. Both are about 1.5" in diameter.
 
  • Like
Reactions: M Rose