Search results

That's would be cool. The normal planning meetings are on the 3rd Thursday of each month at about 6:45pm, so not a Saturday either but for planning meetings, during the week is good.

Love all the custom work!

I would have driven down if it was on a Saturday.

True. Most rebates I've experienced have been with a pre-paid Visa card. I normally spend more than the card so it's not wasted.

That's going to be a fun project! I watch so many van conversions, now I want one, but wouldn't trade my 02, which is not worth much.

On the actual transfer case housing itself. Here is the type of kit they made to address the known issue - Sonnax Transfer Case Pump Plate Kit - 100246-02K

Yeah I was kinda hoping to get the sheen back, but didn't know oxidation would play a part. I'm ok with it getting dingy over time. I keep telling myself, it's an 02, no worries. I believe it's holding up well. I replaced it because it developed a pin hole and fluid was almost near gone by...

Ah oxidation, ok you're right. It's very hard to clean. Definitely leaving it then. Thank you!

Cleaned up my rear diff cover. It was dirty with road grime. Anyone know how to get the shine back? I used a degreaser and just some car soap and water.

Yeah doing so might give her confidence and peach of mind in the technology (Garmin) for her to venture out to remote places.

Maybe make it a positive experience by starting slow, easy roads, and a place with cell service and other amenities. While there have her test out the Garmin until she's comfortable, then work your way to remote places.

Looking at the Morreflat quad+ tire inflator/deflator system.

Yes I'm assuming that would happen. In my case my Yakima wind faring is blocking my roof antennas, so this should reduce the chance if the antenna getting knocked off.

I use a magnet antenna mount on the root. In my case, I could only image that the antenna would just bend back and disconnect from the root instead of break? Only problem or other problem is that it would hang from the cable until I pass the obstacle or temporarily mount it away from low...

Nice install. I like how it's tucked nicely underneath.

You mocking me! lol

Congrats on the 2nd rig!

Yeah what ever you can't go around, you could just go straight through lol.

Thank you, now I see what you mean. She's a beast and that front bar is fierce! Hope no one backs into your wheel fender thingys lol. Awesome!

Some nice rigs!