Recent content by deFine_overland

I have their Nomadic 2. I have the annex, put it on once and then packed it up and will never get it out again. My belief was that it would help with some privacy and have a spot to take off shoes to help keep tent clean. I found however, that because of the place heavy rubber floor it acted...

Unfortunately my reply won’t supply you an affirmative answer to your questions. But, I am in a similar situation and may be able to give you more insight into your issue. I have a 2020 JL Rubicon with a 3.5” Rough Country lift. The only thing I kept from this kit were the lift springs and the...

Nothing more than the stock stuff and some rear control arm protection at the axle. Haven’t found many places where I have trouble with clearance with the 37’s and the 3.5” lift. -DOM

Too much. The cabinets are light. I will have to look up the weight of the fridge and the electrical components. Between the build out and the rear bumper I have a ton of rear sag. I have installed rear spring adjusters but it does not address the fact that the springs are nearly fully...

I would be in but I have a family vacation planned on for the next 2 weekends. Couldn’t do anything until the 25th. Plus you may want that much advance notice or more to get a good turn out.

I would be down, but I have family vacation obligations this weekend all of next week and the following weekend.

No I haven’t had any condensation problems as of yet.

I have a soft side roof top tent. I’m 6’8” 260 pounds and had the same problem. I had a 3” down mattress topper that I put on to of the 3” foam mattress that came with the tent and didn’t make much of any difference. The second problem was that it was then too much thickness to leave the bedding...

Ok, wanted to share this as I think it is a modification that could appear pretty daunting for some, but brought me great return and was pretty straightforward once I figured out some of the challenges. I also want to share because there is no aftermarket solution to this. It’s no secret that...

What does the GG base plate go for? Are you installing this in the Jeep? I will never knock on the quality of their products for two reasons. I haven’t ever seen them in person and everyone has different abilities and priorities, however I just can’t seem to stomach the cost. I ended up...

I’d be up for a meetup like this. Let me know if there is anything I can do to help coordinate this. I am on no other forums or groups.

Thanks for meeting up. Nice to meet other members and I was much more comfortable on that trail with someone else there. until next time, DOM

You still planning to head up?

I believe so. I’m here.